10年治理废气专业公司 集设计、制造、销售、服务为一体

15268541320

  • 催化燃烧设备该如何选择?
  • 本站编辑:湖州绿然环保设备科技有限公司发布日期:2020-11-25 14:17 浏览次数:

选择催化燃烧设备时应留意的事项:

Matters needing attention when selecting catalytic combustion equipment:

(1)废气成分不得含有下列物质:高粘度的油和油。如磷、铋、砷、锑、汞、铅、锡;高浓度粉尘。

(1) The exhaust gas composition shall not contain the following substances: high viscosity oil and oil. Such as phosphorus, bismuth, arsenic, antimony, mercury, lead, tin; high concentration dust.

(2)在选择设备时,应注明废气的组成、浓度和出口温度。

(2) When selecting the equipment, the composition, concentration and outlet temperature of exhaust gas should be indicated.

(3)设备安装现场为无侵蚀性气体,有良好的防雨措施。

(3) The equipment installation site is free of corrosive gas and has good rain proof measures.

(4)设备电源为三相交流380 V,频率50 Hz。

(4) The equipment power supply is three-phase AC 380 V, frequency 50 Hz.

催化燃烧设备的合用范围:

Application scope of catalytic combustion equipment:

主要结果如下:

The main results are as follows

(1)合用于漆丝、机械、电机、化工、仪器、汽车、发念头、塑料、电器等有机废气的净化。

(1) It is suitable for the purification of organic waste gas such as lacquer silk, machinery, motor, chemical industry, instrument, automobile, engine, plastic, electrical appliance, etc.

(2)合用于各种干燥线、油墨、电机缘处理等。

(2) Suitable for all kinds of drying line, ink, motor insulation treatment, etc.

(3)用于苯、醇、酯类、酚、醚、烷烃等混合有机废气的净化。

(3) It is used to purify mixed organic waste gas such as benzene, alcohol, ester, phenol, ether and alkane.

催化燃烧使用表面含有贵金属和金属氧化物的催化剂。在铂和钯的作用下,有机污染物的废气在较低的温度下可氧化为二氧化碳和水。催化剂的加入不能改变原有的化学平衡,变化的只是化学反应的速率,但催化剂本身的性质在反应前后不发生变化。该催化燃烧装置主要由活性炭吸附箱、避雷器、换热器、催化反应床和风机组成。与直接燃烧比拟,催化燃烧温度更低,燃烧更完整。

Catalytic combustion uses catalysts with noble metals and metal oxides on the surface. Under the action of platinum and palladium, the waste gas of organic pollutants can be oxidized to carbon dioxide and water at lower temperature. The addition of catalyst can not change the original chemical equilibrium, only the rate of chemical reaction changes, but the properties of catalyst itself do not change before and after the reaction. The catalytic combustion device is mainly composed of activated carbon adsorption box, lightning arrester, heat exchanger, catalytic reaction bed and fan. Compared with direct combustion, catalytic combustion has lower temperature and more complete combustion.


电话咨询

  • 顾经理:15268541320
  • 关注微信

    返回顶部